Our website has been renewed!

Firmware for CE LITE-50 download

Software License Agreement

It is required to review the following license agreement before the software is downloaded. We will be deemed that the customer has to agree to the terms and conditions of the license agreement when the software had been downloaded by the customer. Please note that it is not possible to download or use the software if the customer does not agree to it.

Downloading Files

Ver.1.20 (Latest version)

Date of updated9 Apr, 2019
Supported ProductsCE LITE-50
Supported OSWindows 11 / 10
Downloading filesSoftwareCELITE_FU(v120).zip (2,376KB)
  • The plotter driver must be installed for use.
  • Please read the update instructions carefully before completing the firmware update.
    If the update is not performed according to the procedure, the cutting plotter may not start.

Revision History


  1. Fixed an adjustment error in the media width sensor adjustment when the adjusted value is abnormal.
  2. Fixed an issue that pen would not stop moving after the finger is removed from the position key.


  1. Changed the operation control to reduce noise. (Further improvement of changes from Ver. 1.05)
  2. Fixed an issue that the origin position moved when the “Carrier Sheet” was repeatedly set.
  3. Fixed an issue where the pull-in operation may not work when loading a fixed size media.
  4. Fixed an issue that off-scale may be displayed on the control panel of CE LITE-50 during feed operation after drawing.
  5. Fixed an issue that off-scale being displayed in some plot data.
  6. Fixed an issue that test cutting in tangent mode would not cut some part of the square.


  1. Fixed an issue where the fan would remain running when returning to the HOME screen after failing to read the barcode.
  2. Changed operation control to reduce operation noise.
  3. Fixed an issue where the segment registration mark of registration mark type 1 could not be read.
  4. Fixed an issue that caused extra feed with the matrix registration mark.
  5. Fixed an issue that caused the copy operation to stop under certain conditions.