Our website has been renewed!

Firmware for CE7000 series download

Software License Agreement

It is required to review the following license agreement before the software is downloaded. We will be deemed that the customer has to agree to the terms and conditions of the license agreement when the software had been downloaded by the customer. Please note that it is not possible to download or use the software if the customer does not agree to it.

Downloading Files

Ver.1.27 (Latest version)

Date of updated1 Nov, 2023
Supported ProductsCE7000-40 / CE7000-60 / CE7000-130 / CE7000-160
Supported OSWindows 11 / 10
Downloading filesSoftwareCE7000_FU(v127).zip (3,431KB)
  • The plotter driver is required to be installed for use.
  • Please update the firmware according to the instructions to start cutting plotter properly.

Revision History


  1. Offline setting function of [Remote Panel Utility] is supported.
    *Do not use flat type setting files.
  2. Fixed the problem that the setting window of [Remote Panel Utility] does not appear.


  1. Some updates have been made to improve serviceability.


  1. Fixed the problem that a “confirming push roller point” error would occur even though the push roller was set on the grit roller.


  1. Fixed the problem that when using the Segment Area Registration Mark, a line segment that was not actually part of the data was drawn when crossing the first segment in some data.
  2. Enhanced error detection of tool position errors.


  1. Fixed the problem that when reloading the media which was loaded once and selecting “CONTINUE” from the Select menu, the origin point when the media was first set was not correctly taken over.


  1. Fixed the problem that when sending cutting data with tool change while Auto Paneling was turned on, extra lines could be cut on the second sheet or incorrect condition numbers could be displayed.


  1. When the “AUTO” was selected in the initial blade control mode selectable function, the pen block moved and hit to the left end in case the specific data was outputted.
  2. When the small size of 4 points Registration mark is detecting, the detecting error was displayed.


  1. Corresponded to the 2.0 mm spacing of barcode. (The scanning time was reduced for the wider spacing of barcode.)
  2. Fixed the problem that the blade consumption alarm of beep was not working for the group 8.


  1. The mode 4 of registration mark scanning was added to detect the high reflective media.
  2. The maximum cutting length for perforation pattern was changed from the 100mm to the 500 mm.
  3. Modifies to select the external clock of CPU to the full speed mode of USB.


  1. The maximum alarm distance for Blade wear alarm setup was changed from the 5 km to the 100 km.


  1. Fixed the problem that the head move without tool position when the tool height did not reset after cutting was finished.