GL260 Q&A (AMP)
-
Configurable span and resolution
-
When a thermocouple is connected for temperature measurement, the temperature is displayed much lower.
-
What is the maximum input voltage?
-
Where should the shunt resistor be connected?
-
What is the maximum voltage that can be applied to the logic/pulse input section?
-
What kind of measurement is the logic input used for?
-
Is differential input possible for analog voltage input?
-
What is the measured input impedance in ohms?
-
Can current (4-20mA) be measured?
-
What is the scan method of input method?
-
What temperatures can be measured with K- and T-type thermocouples?
-
Is it possible to connect the no-voltage contact of a pulse transmitter and count pulses as the totalized flow rate?
-
Does the span setting affect the recorded data?
-
Can AC current be measured?
-
There are some channels that cannot be changed.
-
BURN OUT” is always displayed even though a thermocouple is connected.
-
Can a thermocouple be used to display two decimal places?
-
The amplitude of measured voltage and temperature is large or unstable.
-
Are there any requirements for measurement accuracy in each range?
-
How to Set the position (vertical position) of the input signal.
Other Q&A